Intel Desktop Boards D845GRG and D845GBV 3
Quick Reference
Before You Begin
Warning and Cautions
WARNING
Disconnect the board’s power supply from its AC power source
before you connect or disconnect cables, or install or remove any
board components. Failure to do this can result in personal injury or
equipment damage. Some circuitry on the desktop board can
continue to operate even though the front panel power switch is off.
CAUTION
Electrostatic discharge (ESD) can damage desktop board components.
Install the board at an ESD-controlled workstation. If such a workstation
is not available, wear an antistatic wrist strap or touch the surface of the
antistatic package before handling the board.
CAUTION
Many of the midboard and front panel connectors provide operating
voltage (+5 V DC and +12 V DC, for example) to devices inside the
computer chassis, such as fans and internal peripherals. These
connectors are not overcurrent protected. Do not use these connectors
for powering devices external to the computer chassis. A fault in the load
presented by the external devices could cause damage to the computer,
the interconnecting cables, and the external devices themselves.
Safety and Regulatory Notice
See the Intel Desktop Boards D845GRG and D845GBV Product Guide for all
applicable regulatory compliance statements, product certification markings, and
safety and electromagnetic compatibility (EMC) standards and regulations these
desktop boards are compliant with.
Replacement battery warning label provided: Place the label inside the chassis
in an easy-to-see location near the battery but not on the board itself.
Intended uses: This product was evaluated as information technology
equipment (ITE) for home or office use when installed into an appropriate
computer chassis. Other end uses or locations may require further evaluation.
To Next Page
Loading...
Need help?
General
