Desktop Board Features
13
Main Memory
NOTE
To be fully compliant with all applicable Intel
®
SDRAM memory specifications, the
board should be populated with DIMMs that support the Serial Presence Detect (SPD)
data structure. If your memory modules do not support SPD, you will see a
notification to this effect on the screen at power up. The BIOS will attempt to
configure the memory controller for normal operation.
The Desktop Board has two DIMM sockets that support the memory features listed below:
• DDR3 SDRAM DIMMs with the option in the BIOS setup to raise the voltage to
support higher performance DDR3 SDRAM DIMMs
• Support for:
⎯ Non-ECC DDR3 1333 (overclocking required)/1060/800 MHz memory
Note: DDR3-1333 memory operates at 1066 MHz by default until manually
overclocked through the system BIOS.
CAUTION
Altering PC memory frequency, voltage and/or latency may: (i) reduce
system stability and useful life of the system, memory and processor;
(ii) cause the processor and other system components to fail; (iii) cause
reductions in system performance; (iv) cause additional heat or other
damage; and (v) affect system data integrity. Intel has not tested, and
does not warranty, the operation of the memory beyond its specifications.
Intel assumes no responsibility that the memory, including if used with
altered clock frequencies and/or voltages, will be fit for any particular
purpose. Check with the memory manufacturer for warranty and
additional details.
⎯ Serial Presence Detect (SPD) memory only
⎯ Unbuffered, non-registered single- or double-sided DIMMs
⎯ Memory configurations listed below:
• Up to 2.0 GB utilizing 512 Mb, 1 Gb, or 2 Gb technology
• Up to 4.0 GB utilizing 512 Mb or 1 Gb technology
• 4 GB DIMMs are not supported.
• A minimum of 512 MB of total memory is required
To Next Page
Loading...
Need help?
General
