Intel NUC Kit NUC11PAHi7 User Manual

8
NUC11PAHi7, NUC11PAHi5, NUC11PAHi3, NUC11PAHi70Z, NUC11PAHi50Z, NUC11PAHi30Z
User Guide – April 2022
3.0 Install and Remove System Memory
Intel NUC Kits NUC11PAHi7, NUC11PAHi5, NUC11PAHi3, NUC11PAHi70Z,
NUC11PAHi50Z, and NUC11PAHi30Z have two 260-pin DDR4 SO-DIMM memory
slots
Memory requirements:
• 1.2V low voltage memory
• 3200 MHz SO-DIMMs
• Non-ECC
Find compatible system memory modules at the Intel® Product Compatibility Tool:
• NUC11PAHi7
• NUC11PAHi5
• NUC11PAHi3
• NUC11PAHi70Z
• NUC11PAHi50Z
• NUC11PAHi30Z
3.1 Install SO-DIMMs
NOTE
If you plan to install only one memory module, install it in the lower
memory socket.
To install the SO-DIMMs, follow these steps:
1. Observe the precautions in "Before You Begin" in Section 1.1.
2. Turn off all peripheral devices connected to the computer. Turn off the
computer and disconnect the AC power cord.
3. Align the small notch at the bottom edge of the SO-DIMM with the key in
the socket.
4. Insert the bottom edge of the SO-DIMM into the socket.
5. When the SO-DIMM is inserted, push down on the outer edge of the

Intel NUC Kit NUC11PAHi7 Specifications

General

Brand	Intel
Model	NUC Kit NUC11PAHi7
Category	Computer Hardware
Language	English