Intel NUC Kit NUC7i7BNH, NUC7i5BNH & NUC7i3BNH User Guide
5
Installing and Removing Memory
Intel NUC Kits NUC7i3BNH and NUC7i5BNH have two DDR4 SO-DIMM sockets. Memory requirements:
• 1.2V memory
• 1866 MHz or 2133 MHz SO-DIMMs
• Non-ECC
For a list of tested memory, go to the Intel® Product Compatibility Tool:
• NUC7i7BNH
• NUC7i5BNH
• NUC7i3BNH
Install SO-DIMMs
If you plan to install just one SO-DIMM, install it in the lower memory socket.
To install the SO-DIMMs, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.
2. Turn off all peripheral devices connected to the computer. Turn off the computer and
disconnect the AC power cord.
3. Align the small notch at the bottom edge of the SO-DIMM with the key in the socket.
4. Insert the bottom edge of the SO-DIMM into the socket.
5. When the SO-DIMM is inserted, push down on the outer edge of the SO-DIMM until the
retaining clips snap into place. Make sure the clips are firmly in place.
Removing SO-DIMMs
To remove a SO-DIMM, follow these steps:
1. Observe the precautions in "Before You Begin" on page 2.
2. Turn off all peripheral devices connected to the computer. Turn off the computer.
3. Remove the AC power cord from the computer.
4. Remove the computer’s cover.
To Next Page
Loading...
Need help?
General
