(150IO) AP620C BUILT-IN ELECTRIC PUMP ENGLISH 4.875” X 7.25” 06/16/2019
English
150
IO
SAVE THESE INSTRUCTIONS
Page 3
INFLATION
1. Plug in the AC line cord into an AC electrical outlet. See Fig
(1)
.
2. Slide the switch left to the inflation mark (
). See Fig
(2)
.
3. When the airbed is fully inflated to the desired firmness, slide the switch right to the Off
mark (
).
4. Lie down on the airbed to test the firmness.
5. If the sleeping surface is too hard, adjust the firmness by slowly sliding the switch right
to the deflation mark ( ). See Fig
(4)
. Slide the switch left to the Off mark ( )
when the desired firmness is achieved. See Fig
(5)
. If the airbed becomes too soft
repeat step #2 thru #5 as necessary.
FIG (1)
110 -120 V220 – 240 V
FIG (2)
6. Disconnect the AC line cord from the wall socket, place it inside the cord compartment.
FIG (5)
FIG (4)
FIG (3)
√
Never disconnect the power line cord from the pump or from the electrical outlet while the pump
is operating. Switch OFF ( ) the pump first before disconnecting the power line cord.
IMPORTANT
To Next Page
Loading...
Need help?
General
