(257PO) MODEL 601 FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 05/31/2021
English
SAVE THESE INSTRUCTIONS
Page 10
257
PO
PROBLEM
ALGAE
COLORED
WATER
FLOATING
MATTER IN
WATER
CHRONIC LOW
WATER LEVEL
SEDIMENT
ON POOL
BOTTOM
SURFACE
DEBRIS
COMMON POOL PROBLEMS
DESCRIPTION CAUSE SOLUTION
• Greenish water.
• Green or black spots
on pool liner.
• Pool liner is slippery
and/or has a bad
odor.
• Water turns blue,
brown, or black
when fi rst treated
with chlorine.
• Water is cloudy or
milky.
• Level is lower than
on previous day.
• Dirt or sand on pool
fl oor.
• Leaves, insects etc.
• Chlorine and pH levels
need adjustment.
• Copper, iron or
manganese in water
being oxidized by the
added chlorine. This is
common.
• "Hard water" caused by
a too high pH level.
• Chlorine content is low.
• Foreign matter in water.
• Rip or hole in pool liner
or hoses.
• The drain valves are
loose.
• Heavy use, getting in
and out of pool.
• Pool too close to trees.
• Super chlorinate with shock
treatment. Correct pH to your pool
store's recommended level.
• Vacuum pool bottom.
• Maintain proper chlorine level.
• Adjust pH level to the recommended
level.
• Run fi lter until water is clear.
• Clean cartridge frequently.
• Correct the pH level. Check with
your pool dealer for advice.
• Adjust the chlorine level.
• Clean or replace your fi lter.
• Repair with a patch kit.
• Finger tighten all caps.
• Use Intex pool vacuum to clean
bottom of pool.
• Use Intex pool skimmer.
IMPORTANT
If you continue to experience diffi culty, please contact our Consumer Service
Department for assistance. See separate “Authorized Service Centers” sheet.
To Next Page
Loading...
Need help?
General
