EasyManuals Logo
Home>Intex>Boat>Excursion 4 Set

Intex Excursion 4 Set User Manual

Intex Excursion 4 Set
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
(98IO) “ISO” BOAT W / MOTOR MOUNTING (TYPE II) ENGLISH 4.875” X 7.25” 05/13/2022
SAVE THESE INSTRUCTIONS
Page 11
98
A
Grab Line Installation (Certain Models):
IMPORTANT:
To properly install the inflatable boat’s grab line and/or accessory
lines, first inflate the boat.
If is necessary, begin the grab line installation at
the rear of the boat by threading it through the rope
holders completely around the outside of the boat.
Tie the two loose ends in a square knot at the rear
end of the boat.
Accessory Line Installation (Certain
Models):
Your boat may have accessory lines to
install. Tie a figure eight knot into one end
of the accessory line and slide it through
the rope holders. Tie a figure eight knot in
the remaining end of the rope. The
accessory bags may or may not be
attached to the accessory lines. Slide the
rope through the accessory bags while
installing the accessory lines, if desired.
Safety and Operating Instructions
Before Departing from the Shore or Dock
Know all required information and inform your passengers:
Take a boating safety course and get hands-on training from your boat dealer or local
boating authorities.
Know all local regulations and hazards related to water activities and boat operation.
Check weather forecast, local currents, tides and wind conditions.
Advise someone on land of the time you plan to be back at your starting point.
Explain basic boat operation to all passengers.
Children and non-swimmers need special instructions in the use of life jacket or personal
floatation devices (PFD).
Be sure that one of your passengers can operate the boat in case of emergency.
Learn how to determine the distance you can cover, and remember that bad weather
conditions can alter this.
Review all safety requirements regularly.
Check the working condition of the boat and equipments:
Check inflation pressure.
Inspect the valves caps.
Check the load is evenly distributed, fore (front) to aft (back) and side-to-side.
Make sure that all required safety equipment is on board (check the laws and
regulations of the country or locality in which you are boating to see if additional
equipment may be needed):
One personal flotation device (PFD) per person.
Air pump, oars, repair kit and tool kit.
Any other mandatory equipment.
The boat papers and your boating license (if applicable).
Lights are required if operating after dark.
Figure eight knot
Square knot

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intex Excursion 4 Set and is the answer not in the manual?

Intex Excursion 4 Set Specifications

General IconGeneral
BrandIntex
ModelExcursion 4 Set
CategoryBoat
LanguageEnglish

Related product manuals