(97IO) DELUXE MAINTENANCE KIT ENGLISH SIZE: 4.875” X 7.25” PANTONE 295U 05/26/2022
97
A
SAVE THESE INSTRUCTIONS
Page 14
POOL VACUUM SETUP INSTRUCTIONS
10
WARNING
• Do not permit children to use this product. Adult use only.
• Remove all maintenance items when the pool is in use.
The pool vacuum is now ready to use.
1. The filter pump is an airtight system. To eliminate air trapped in the hose or in
the pump, turn the top air release valve 1-2 turns in a counter-clockwise motion
to open the valve.
2. When water starts flowing out of the air release valve hole, screw in the air
release valve back into the filter housing cover. Do not over tighten the valve.
3. Connect the filter pump to the power outlet and turn ON the pump.
4. In soft gentle strokes "sweep" the entire bottom surface of the pool liner until it’s
clear of debris.
5. Make sure the filter pump is turned off, and disconnect the power cord from the
electrical outlet. Remove the pool vacuum from the pool.
6. Using the Set-Up instructions in reverse, disassemble the vacuum cleaner.
Clean the debris bag if necessary.
7. Store the pool vacuum in an area where it will not be a safety hazard.
If you experience low suction on the vacuum, check that all of
the air has been removed from the hose. If you still have a low
suction problem, please review the Troubleshooting Guide for
your filter pump under "Filter pump does not pump water or flow
is very slow". Also, check that the debris bag is clean.
IMPORTANT
POOL VACUUM OPERATING INSTRUCTIONS
To Next Page
Loading...
Need help?
General
