To Next PageTo Next PageTo Previous PageTo Previous Page
What to do if Intex Water Pump filter motor fails to start?
If your Intex water pump's filter motor isn't starting, ensure it's plugged into a 3-wire outlet protected by a Ground Fault Circuit Interrupter (GFCI) or RCD. Try resetting the circuit breaker. If it trips repeatedly, there may be an electrical system defect, so turn off the breaker and call an electrician. Also, the motor might be too hot, so allow it to cool down.
Why is my Intex Krystal Clear CS7221 Water Pump filter not pumping water or the flow is very slow?
The issue might be due to several reasons. First, check for any blockages in the inlet or discharge. Clear any obstructions in the intake hose. Second, inspect the intake line for air leaks, tighten hose nuts, check hoses for damage, and verify the pool water level. Third, scale or buildup on the cartridge may be the cause, so replace the cartridge. Also, consider cleaning the cartridge more often. Finally, clean inside the plunger valve and ensure the valve handle is in the full upright position.
What to do if my Intex Krystal Clear CS7221 doesn't work?
If your Intex water pump isn't working, first ensure the pool is filled to the correct water level. Next, clean the strainer screens at the pool inlet. Then, check for air leaks on the intake hose by tightening hose nuts and inspecting the hose for damage. Clear any sticks or leaves in the intake hose. Turn and pull the valve handle to the full upright position. Unscrew the two air release valves on the chamber to fill it with water.
General| Model | CS7221 |
|---|---|
| Type | Sand Filter Pump |
| Tank Diameter | 14 inches |
| Filter Media | Sand |
| Voltage | 110-120V |
| Frequency | 60 Hz |
| Hose Diameter | 1.25 inches |
Details the process of generating chlorine using the saltwater system.
Explains the process of generating copper ions for algaecide properties.
Lists the technical specifications of the saltwater system, such as wattage and output.
Information on salt type, optimum levels, and addition/removal procedures.
Formulas for calculating pool volume in gallons and cubic meters.
Instructions for initial startup, setting operating hours, and locking controls.
Guidance on testing copper levels and how to readjust operating time.
Step-by-step guide to clean the flow sensor and its conduit.
Instructions for periodic manual cleaning of the electrolytic cell.
How to use copper ion and 3-way test strips for pool water analysis.
Procedures and conditions for storing the unit when not in use.
