Intex PureSpa SSP-H-10-1 User Manual

263
PO
S AVE THESE INSTRUCTIONS
(263PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/16/2014
English
Page 12
LED CODE CHART
E90
No water fl ow
•
Turn off and unplug the control unit.
•
Ensure the outlet cover grid is clean and free
from obstructions.
•
Clean or replace the cartridge, see
Maintenance and Storage section.
•
Ensure the in/outlet connections on the spa tub
and fi lter pump are not blocked.
•
Keep the spa water properly sanitized to
ensure a clean and unclogged fi lter cartridge.
•
If problem persists, contact Intex Service
Center.
E94
Water temperature too low
•
If the ambient temperature is below 39°F (4°C),
we recommend not to use the spa.
•
Turn off and unplug the control unit, add some
warm water to raise the spa water temperature
above 41°F (5°C), then press the button to
heat up the water to the desired temperature.
•
Press the temperature increase button to set
the desired water temperature.
•
If problem persists, contact Intex Service
center.
E95
Water temperature too high
•
Turn off and unplug the control unit. When the
water has cooled down, plug the GFCI/RCD
and restart all over again.
•
Turn the heater off, then press the fi lter and
bubble buttons to lower the water temperature.
•
If problem persists, contact Intex Service
Center.
E96
System Error
•
Turn off and unplug the control unit, use the
cap to stop the water from fl owing out of the
tub, disassemble and drain out the control unit.
Reassemble the control unit back to the tub.
Plug the GFCI/RCD and restart all over again.
•
If problem persists, contact Intex Service
Center.
E99
Water temperature sensor broken
•
Contact Intex Service Center.
END
After 72 hours of operation,
the pump will hibernate and
the rapid heating and water
fi ltration functions are disabled.
•
Press the button to re-active the
fi lter pump.
LED Reading CAUSE SOLUTION

Intex PureSpa SSP-H-10-1 Specifications

General

Brand	Intex
Model	PureSpa SSP-H-10-1
Category	Hot Tub
Language	English