Intex Quick-Fill AP642 User Manual

166
IO
(166IO) AP642 ELECTRIC PUMP ENGLISH 4.875” X 7.25” 05/23/2019
SAVE THESE INSTRUCTIONS
Page 2
PARTS DESCRIPTION:
1. PUMP
2. INFLATION CONNECTOR
3. DEFLATION CONNECTOR
4. SWITCH
5. DETACHABLE 12V DC
POWER CORD
6. AC ADAPTER
7. NOZZLES
8. SWITCH OPERATION DETAIL
9. VENT HOLES / SLOTS
Inflate and deflate
with batteries.
Inflate and deflate
with DC power.
Inflation OFF and recharge mode ON with AC or DC power.
8
9
1
2
5
6
3
4
NAMES OF PARTS
7
INSTRUCTIONS
General
•
Pump must be charged before use and is not designed for inflation directly from household AC
power sources.
• Itisrecommendedthatthefirstchargetobe10hoursorovernightusingtheACadapterpoweredby
household 220-240 AC voltage.
• Ifnecessary,theinitialchargecanbemadeusingtheDCpowerCordpluggedintoanautomobile
cigarette lighter or 12V DC accessory receptacle for one hour. After the first charge, it may be used
for inflation (without cords) and recharged using either the AC Adapter or Fast-charged (1 hour only)
using the 12 Volt DC Power Cord. See specific instructions below.
• Theexternalflexiblecableorcordofthistransformercannotbereplaced.Ifthecordisdamaged,
the transformer shall be scrapped.
• The“ ” position turns the pump OFF and is also the RECHARGE mode position.
• Thebatteriesarepermanentlysealedinthepumpandcannotberemovedorreplaced.Asthepump
weakens from use, recharge the batteries. Do not wait until they are fully discharged.
• This product contains sealed non-replaceable nickel metal-hydride (Ni-MH) rechargeable batteries.
Do not dispose of the product in regular trash, municipal waste stream or by fire as the built-in
rechargeable battery may leak or explode. Always dispose of the batteries safely in accordance with
your local law and regulations.
• Thebatterymustberemovedfromtheappliancebeforeitisscrapped.
• Theappliancemustbedisconnectedfromthesupplymainswhenremovingthebattery.
• Keep away from heat or direct sunlight.
• Return pump, DC power cord, AC adapter and nozzles to package when not in use.
• Nospecificairpumpmaintenanceisrequired.

Intex Quick-Fill AP642 Specifications

General

Brand	Intex
Model	Quick-Fill AP642
Category	Water Pump
Language	English