Intex SF20110 User Manual

(127) MODEL SF20110 SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/26/2012
127
SAVE THESE INSTRUCTIONS
Page 11
English
PRODUCT SPECS & SETUP INSTRUCTIONS
PRODUCT SPECIFICATIONS
SETUP INSTRUCTIONS
Power: 110-120 Volt AC
Amperage: 6.0 A
Maximum working pressure: 3.5 bar (50 psi)
Effective filtering area: 0.13 m
2
(1.44 ft
2
)
Maximum Flow Rate: 10030 liters/hour (2650 gallons/hour)
Recommended filtering media: No.20silicasandorglasssand.Particlesize
(Notincluded) range 0.45 to 0.85 mm (0.018 to 0.033 inches).
Uniformity Coefficient less than 1.75.
Recommended filtering media quantity: No.20silicasand 45Kg(100Lbs) or glass
sand 32Kg(70Lbs).
Limited Warranty: see “Limited Warranty”
NOTE: NOTSUITABLEFORUSEWITHKCP-LOW-SALTAUTOMATICSALTWATER
SYSTEM(MODEL6110/6220 )
The sand filter removes suspended particles but does not sanitize your pool.
Pool chemistry is a specialized area and you should consult your local pool
service specialist for details.
TOOLS REQUIRED: One (1) Phillips screwdriver
Pump location and mounting:
• Thesystemmustbeinstalledonasolidlevelandvibration-freebase.
• Providealocationprotectedfromtheweather,moisture,floodingand 
freezing temperature.
• Provideadequateaccess,spaceandlightingforroutinemaintenance.
• Pumpmotorrequiresfreecirculationofairforcooling.Donotinstall 
the pump in a damp or non-ventilated location.
A team of 2 or more people is recommended for setting up this product.
Motor pre-filtering assembly setup:
1. Remove the sand filter and its accessories
from the packaging carefully and inspect for
any visible damage. If parts are damaged
contact your local service center listed at
the back of this owner’s manual.
2. In a counter-clockwise motion unscrew the
leaf trap cover (14) from the pre-filter
housing. Take out the basket (16) and filter
housing nut (17) (see drawing 10).
3. Connect the pre-filter housing to the motor
  waterinlet.Note: Align the connector in the
pre-filter housing with the water inlet on the
motor (see drawing 11).
10
11
35
17
16
14

Intex SF20110 Specifications

General

Brand	Intex
Model	SF20110
Category	Swimming Pool Pump
Language	English