(127) MODEL SF20110 SAND FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/26/2012
127
SAVE THESE INSTRUCTIONS
Page 13
English
SETUP INSTRUCTIONS (continued)
SETUP INSTRUCTIONS
Sand loading:
IMPORTANT: Use No. 20 silica sand or glass sand with particle size range
0.45 to 0.85 mm (0.018 to 0.033 inches) and a Uniformity Coefficient less
than 1.75.
NOTE: Before loading the tank with sand, ensure the center pipe hub
assembly is securely in place at the bottom of the tank, and vertically
centered inside the tank.
1. Place the sand shield (6) over the top of the center pipe. Pour the sand into the
tank at a slow rate. (see drawing 15).
2. Fill the tank approximately half way, remove the sand shield (6) from the top.
(see drawing 16).
3. Evenly distribute the sand inside the tank, then fill the tank with some water to
provide a cushioning effect when the remaining sand is poured in. This
prevents the center pipe hub (7) from excessive shock (see drawing 17).
Place the sand shield (6) back and continue to pour the sand into the tank.
4. Sandshallbefilledbetweenthe“MAX”and“MIN”markedgaugeonthecenter
pipe. Evenly spread and level out the sand by hand (see drawings 17 & 18).
5. Remove the sand shield (6).
6. Wash away all sand around the top edge of the tank.
15
16
6
6
MAX
MIN
17
MAX
MIN
MAX
MIN
18
7
7
To Next Page
Loading...
Need help?
General
