(368IO) RECHARGEABLE HANDHELD VACUUM ENGLISH SIZE: 4.875” X 7.25” 05/25/2023
368
IO
SAVE THESE INSTRUCTIONS
Page 4
Operation:
1.
Make sure the charging receptacle is securely
covered with the rubber flap first. Press the
power button first, the battery indicator light
will turn on. Then place the vacuum in the
water. Please note that if the battery has
no power, the vacuum motor will stop
working, but the indicator light will still
be on. At this point you must recharge
the battery. See fig 6.
Note:
Always turn off the power button when the device is not in use or during long term
storage in order to prevent damage to the battery.
2.
Carefully “sweep” the surface of the spa or pool to remove debris.
3.
Check and empty the filter bag/micro-filter bag regularly during and after each use.
4.
Reverse the above installation steps to remove and empty the filter bag/micro-filter bag.
Note:
Rinse vacuum body, cover and filter bags with a garden hose before reassembling.
Maintenance and long term storage:
1.
Turn off the vacuum before cleaning, servicing and maintenance. Regularly check all
components for sign of damage. Discard and replace damaged components immediately.
2.
Using the installation instructions in reverse, disassemble the vacuum. Clean all the
components with water, and make sure all components are thoroughly dry before storage.
3.
Store the product and accessories in a dry, temperature controlled, between 0º – 40ºC
(32º – 104ºF), storage location.
4.
To protect and extend the life of the battery, make sure the battery is charged before long
term storage, and charge the battery every 3 months thereafter.
5.
The original packing can be used for storage.
TROUBLE SOLUTION
VACUUM DOESN’T
WORK
• Charge the product then turn on the unit. Ensure the power button is on.
• Keep the vacuum body under the water.
LOW SUCTION
• Choose the suitable bag for filtering and install the filter bag(s) correctly.
• Check and empty the filter bag(s) regularly during and after each use.
• Check for any sand or deposits in the vacuum.
• Check if the battery power is too low. If it is too low, recharge it.
• Contact Intex Service Center.
CHARGING FAILED
• Plug the charger (not included) into the main electrical outlet first, then
connect the USB cable into the vacuum body charging receptacle.
• Ensure the charger cable is securely inserted into the charging receptacle,
the indicator light should be on.
DOESN'T CLEAN
THE POOL
• Check if the battery power is too low. If it is too low, recharge it.
• Use the correct vacuum head: use the large vacuum brush head for
flat open surfaces, and the vacuum nozzle head for corners, steps and
uneven surfaces.
• Use the correct filter bag, see “Installation” section.
• Ensure the vacuum head or nozzle is close to the surface of the wall or
floor, and reduce the sweeping movement and speed during vacuuming.
• The bristles of the vacuum brush head are worn out, replace a new brush
head.
• For heavy stains on the pool wall, it’s recommended emptying the pool
and scrub the wall with mild detergent.
Fig 6
To Next Page
Loading...
Need help?
General
