cleaning & maintenance
5
4.3 Switching on
Slide the ON/OFF switch (6) on the side of the control (2) to position 1 ( I ), to switch the electric blanket on.
When it is switched on, the LED indicator for temperature setting 1 lights up.
4.4 Setting the temperature
Press the button (4) to increase the temperature.
Press the button (5) to decrease the temperature.
Setting 0: OFF
Setting 1: minimum heat
Setting 2: medium heat
Setting 3: maximum heat
Stand
: maximum heat - just the feet area
CAUTION
If the electric underblanket is used continuously (for several hours)
it is recommended to use the lowest setting (1) of the control to
avoid overheating of the user.
NOTE
• The quickest way to heat up the electric underblanket is to select the highest temperature setting of the control, first.
• We strongly recommend switching on the electric underblanket approx. 30 minutes before going to bed and
covering it with the quilt to prevent the warmth from escaping.
4.6 Switching off
Slide the on-/ off button (9) at the side of the control to position 0, to switch the electric blanket off.
WARNING
Always remove the supply plug from the mains outlet and remove the control from the electric underblanket by
disconnecting it at the connector.
CAUTION
The control must never get in contact to water or other liquids. Otherwise, the control may be damaged.
• To clean the control, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
• Small marks on the electric underblanket can be removed with a damp cloth or sponge, or if necessary, with a little liquid detergent
for delicate laundry.
NOTE
If the electric underblanket is not used for several days, set the ON/OFF switch to the OFF (0) position and remove the mains
plug from the socket. Then remove the control from the electric underblanket by disconnecting it at the connector.
4.5 Automatic switch off
This electric underblanket switches off automatically after 12 hours. Once the electric underblanket has switched off, it is no longer
heated and the LED indicator for temperature setting 1 flashes.
To switch on the electric underblanket again, first set the ON/OFF switch on the side of the control to the OFF ( 0 ) position for 5
seconds. Then set the ON/OFF switch back to ON ( I ) and select the desired temperature setting.
18
• English
To Next Page
Loading...
Need help?
General
