Check for parts online at www.ioniceaugers.com or call 800-345-6007 M-F 8-5 CT
4
Operator's Manual
ION G2 Electric Ice Auger
IMPORTANT
CHARGERS COME PACKAGED SEPARATELY IN
THE AUGER CARTON. BATTERY MUST BE FULLY
CHARGED BEFORE FIRST USE.
AUGER
FLITE
BLADE
PROTECTOR
LITHIUM
BATTERY
CAUTION:
SHARP EDGES
AUGER
RING
Important Safety Precautions
• The ice blades are very sharp. Use extreme caution
when drilling a hole or replacing the blades. Put the
blade guard on after each use.
• Always keep hands, feet, hair, drawstrings, scarves,
hats and loose clothing away from any moving parts
on the unit.
• Do not allow children to operate this unit. Do not
allow adults to operate the unit without proper
instruction.
• Do not operate any power equipment under the
inuence of alcohol or drugs.
• Keep all screws, nuts and bolts tight.
• The battery must be removed before any repairs are
attempted.
• If the unit becomes stuck in a hole, remove the battery
before attempting to remove the unit manually.
• DO NOT use this product for anything other than its
intended purpose.
• DO NOT use attachments and accessories other than
those available from ION.
• DO NOT alter this product in any manner; doing so is
dangerous and will void the warranty.
• DO NOT continue to use this product in the event of
mechanical failure.
• This product produces considerable torque that is
felt by the operator. Make sure your feet are rmly
planted and that the handles are held rmly while
operating the auger.
• During operation, the unit could stop. If this happens,
release the operating trigger. Reposition your feet
and grip the handles tightly. Then squeeze operating
trigger and lift the unit gently.
• When drilling ice holes, do not push down on the unit.
If auger begins to drill slowly, blades may need to be
sharpened or replaced.
• DO NOT discard the battery into trash can. Discard
the battery according to your local, state, federal or
country’s regulations.