B. Install a faucet bracket (included) instead of drilling a hole (Optional)
a. Mount the bracket to the sidewall of the cabinet.
b. Insert the faucet stem into the hole on the bracket. Slip on the back rubber washer.
c. Tighten the nut with the plastic wing.
d. Insert the tubing about 1/2" into the push-in fitting and secure it with the clip.
How to Drill a Hole in Sink or Counter-top
1. It is highly recommended that you watch the YouTube video "How to Drill Faucet Holes."
2. Choose a 1/2" Diamond Core Bit for granite and a titanium drill bit for steel. Do NOT use a
hammer drill on natural stone, glass, and ceramic.
3. An indent should be made with a punch on steel before drilling to help guide the bit.
4. Use caution when drilling on a Porcelain sink, as it could be easily chipped - set drill speed
on slow. Press the bit downward firmly until it breaks through the slippery surface.
5. Use a coolant to disperse heat. Choose water for granite and oil for steel. Use the Water
Suction Cup to hold coolant inside and prevent the drill bit from slipping.
6. Hold the drill firmly and vertically at the slowest speed to prevent the drill bit from slipping
on the counter.
7. Once you break through the smooth surface, swirl the drill a little to evenly apply pressure
in a circle. Be patient and deliberate. It can take 20 - 40 minutes to drill through 1".
Step 3: Install the System
A. Place the system on a flat surface.
B. *(Optional) Match the stage labels and twist filter cartridges counterclockwise into the machine
head in order.
C. *(Optional) Use the included screws to hang the system on the wall.
Page 5 www.123filter.com | (678) 261-7611 | support@123filter.com
To Next Page
Loading...
Need help?
General
