Inspection and Installation
Copyright © Itech Electronic Co., Ltd. 3
1.3 Adjustment of Handle
IT6800 series power supplies are equipped with a handle for user to easily
carry and place it.
The power supply handle may be adjusted based on three methods (as shown
in icons below). Be sure that appropriate force is applied to adjust the power
supply handle to appropriate position.
1.4 Disassembly of Handle
Please disassemble the load handle before installing equipment on the support.
Disassembly steps:
1. Rotate the handle to the desired position.
NOTE
To easily disassemble handle, align the locking mouth and locking device, which is between
the handle and the instrument
2. Align the locking mouth, and pull out the handle towards two sides.
NOTE
Do not use too much force and mind your hands during disassembly of power supply handle.
1.5 Rack Mounting
This instrument can be installed on standard 19-inch rack. ITECH provides user
with IT-E151/IT-E151A rack, as an optional mount kit. The detailed operation
please refer to the User Manual of your mount kit.
1.6 Connecting the Power Cord
Connect the power cord after checking that the power switch of the instrument
is turned OFF. Only use the power cord supplied as a standard accessory.
Select from the following Schedule of Power Cord Specifications an appropriate
power cord that matches the voltage for the area in which you use the
instrument. If the power cord included in the instrument you purchased does
To Next Page
Loading...
Need help?
General
