Automatic Test Function
Copyright © Itech Electronic Co., Ltd. 47
The first step: CC mode, current 2A, the upper limit voltage value is 10V, and
the lower limit voltage value is 2V.
1. Press [CC], set the current to 2A, and then press [Shift]+[CV] (Setup) to
enter the setting interface.
RANGE=30.000A
CC
2. Set the maximum working current, and press [Enter] to confirm.
RANGE =2.000A
CC
3. Set the upper limit of voltage, press [Enter] to confirm.
HIGH=10.00V
CC
4. Set the lower limit of voltage, press [Enter] to confirm.
LOW=2.000V
CC
5. Set the rising slope of current, press [Enter] to confirm.
UP=1A/uS
CC
6. Set the descending slope of current, press [Enter] to confirm.
DOWN=1A/uS
CC
The parameter settings are complete.
10.0000V 0.000A
0.00W I=2.000A
7. Press [Shift] + [4] (Save) to enter the save settings interface. Press
numeric key [1] twice to save the current step as the first step of Program
2.
SAVE 11
The second step: CV mode, voltage 3V, the upper limit current value is 5A, and
the lower limit current value is 0A.
1. Press [CV], set the voltage to 3V, and then press [Shift]+[CV] (Setup) to
enter the setting interface.
RANGE=120.00V
2. Set the maximum working voltage, take 3V as example, and press [Enter]
to confirm.
RANGE=3.00V
3. Set the upper limit of current, press [Enter] to confirm.
HIGH=5.000A
4. Set the lower limit of current, press [Enter] to confirm.
LOW=0.0000A
The parameter settings are complete.
10.0000V 0.000A
0.00W V=3V
5. Press [Shift] + [4] (Save) to enter the save settings interface. Press
numeric keys [1] and [2] to save the current step as the second step of
Program 2.
To Next Page
Loading...
Need help?
General
