8.6.
Spray nozzles and connecting pipes
1)
Remove the curtain (it can be cleaned with vinegar or phosphoric acid, rinse, clean with lye,
rinse)
2)
Remove the metal grill and clean likewise.
3)
PULL UPWARDS THE CONNECTING PIPE. IT HAS BEEN ASSEMBLED BY PRESSING
IT INTO PLACE.
4)
Disassemble the nozzles and the connecting tube covers and clean them.
5)
Disassemble and clean the main filter of the production unit. (IT IS ASSEMBLED BY
PRESSING IT INTO PLACE)
6)
Assemble the filter, nozzles and connecting tube.
ATTENTION: IT IS ESSENTIAL THAT SPRAY NOZZLES ARE COMPLETELY
PERPENDICULAR TO THE CONNECTING TUBES, OTHERWISE THE CUBES AT THE
ENDS MAY NOT RECEIVE WATER.
7)
Place the grill over the nozzles, with the back slots secure.
8)
Install the curtain, ensuring that all of the strips can move freely.
9)
Run the machine but DISCARD THE FIRST SET OF ICE CUBES
8.7.
Cleaning the water inlet filters
These round wire gasket filters placed on either end of the water hose to mains, often become
blocked in the first few days of use, Especially When The Plumbing Installation Is New. Clean
them under a jet of water.
8.8.
Checking for water leaks
This must be done whenever maintenance is carried out on the machine: check all water
connections, braces, tubes and hoses in order to eliminate leaks and prevent breakages and
flooding.
To Next Page
Loading...
Need help?
General
