29
E
6.1. Transportation
Note The LATENTO XXL must always be delivered in a standing posi-
tion so as to avoid any damage!
The LATENTO XXL may be tilted max. horizontally for a short time, e.g. when car-
rying it to the place of installation. Great care must be taken that the cover was
closed with all screws.
6.2. Mounting
Heed the following points when selecting the installation site for the LATENTO XXL:
frost-protected room.
level, clean swept floor.
do not subject the LATENTO XXL to direct solar radiation
(the UV can destroy the plastic).
Heed the load-bearing capacity of the foundation, the filled LATENTO XXL
weighs approx. 410/660 kg (XXL 300/500).
keeping heat-losses as little as can be, place the LATENTO XXL in the vicinity of
the reheating heat generator.
If possible, mount system in a heated room to minimize heat-losses
(ENEV – Energy Saving Decree).
Note For operation with electrical heating element (878 700 039):
The screwing of the electrical heating element into the LATENTO
storage tank should take place before its filling and piping.
In areas with low room height it can be necessary to tilt the
LATENTO storage tank in order to insert the electrical heating
element.
To Next Page
Loading...
Need help?
General
