13
600 Series
Turfcat
Tractors
ENGINE OIL
See Engine Manual for manfacturer's recommendations. Before using the machine for the first time, check the
oil level in the engine crankcase with crankcase dipstick D. When checking oil level, make sure the machine is
on level ground.
To change engine oil:
1. First warm up the engine. Shut off engine when
warm, remove oil drain plug P and drain the oil
from the sump.
2. Clean plug and replace.
3. Re-fill sump at S with the recommended engine
oil.
NOTE: After oil has been added, wait one minute and
then check level of oil again with the dipstick D.
Engine oil filter:
– The oil filter cartridge O is easily reached at the
right side of the tractor.
– See the tractor service chart or recomendations of
the engine manufacturer for proper replacement
intervals.
– Apply a thin film of oil to the seal when replacing
the cartridge. Check for leaks after starting the
engine.
– Check oil using dipstick D and top off if
necessary.
MAINTENANCE
To Next Page
Loading...
Need help?
General
