Jacuzzi BALI User Manual

35
Q We recommend adjusting the water temperature to the desired value, holding the
shower head and turning the ring nut (G) on the diverter to position (d).
Pull the mixer lever (R) to allow the water to run and turn it to adjust the temperature.
QWhen the water has reached the desired temperature, turn the ring nut (G) to the de-
sired position.
shower head
shower
waterfall
vertical hydro jets
CONTROL PANEL
QBali shower (1) QBali hammam (2)
1: on/o; 1: on/o;
2: fan and related LED indicator; 2: fan and related LED indicator;
3: lighting system; 3: lighting system;
4: radio/Bluetooth®; 4: radio/Bluetooth®;
5/7: volume adjustment; 5: volume adjustment/ frequency adjustment;
6/8: radio frequency adjustment; 9: steam bath and relative led indicator;
10: steam bath adjustement;
11: radio frequency storage;
12/13: parameter adjustment;
QTurn the power on using the main switch up from the shower unit:
Bali shower
The display shows a light spot, indicating that the functions can be activated (stand-by
mode).
Bali hammam
The display emits an acoustic signal, indicating that the functions can be activated (stand-
by mode).
Bali shower
Q If 3 lines (---) are not shown on the display, press the "on/o" button
.
Bali hammam
Q Press the "on / o" key : the display shows the temperature value of the zone-box
(you can set the unit of measurement in degrees ° C or ° F, refer to the relevant chapter).
Note: after about 60 minutes from activation, the shower box switches o automatically.
All models
Once the control panel is switched on, the lighting system is activated (the color of the light
varies over time according to a pre-established sequence).
Q Then activate the desired function using the relevant button.
Manual functions
R
G
H
C
d
VOL +
TUN +
TUN −
VOL –
1
2 9
5
11
13
10
4
12
1 3
3
2
4
6
5
7
8
12
Switching on the shower unit;
in stand by
Activating the control panel

Jacuzzi BALI Specifications

General

Brand	Jacuzzi
Model	BALI
Category	Bathroom Fixtures
Language	English