48
1
2
Turning on power
• (fig. 1) Press and release the indicated key within 2 sec-
onds. The white light will come on. You can now choose from
5 other steady lights, or from one of the four available colour
s
equences (cycles).
Selection of steady colours
• Press and release again, within 2 seconds, the key shown
i
n fig. 1: light will change from white to sky blue.
• To move on to the next colour, press the same key again. The
sequence of steady colours includes the following:
- white
- sky blue
- orange
- yellow
- green
- magenta (purplish red)
• After the last colour, the sequence starts again from white,
and so on.
Selecting a cycle of colours
• (fig. 2) To activate a colour cycle, press and release within
2 seconds the corresponding key.
• To change from one cycle to another, press and release the
key for the required cycle within 2 seconds.
Shutdown
• (fig. 1) Hold the indicated key down for at least 2 seconds.
• The “Cromodream
®
” function can be used with any show-
er enclosure function.
• While a cycle is running, if you press the key in fig. 1, the
cycle is interrupted and the light takes on a steady colour.
• During a colour cycle, if you hold down a key for a colour
sequence for at least 2 seconds, the cycle is interrupted and
the light takes on the steady colour that was active before
the cycle started.
• Each colour cycle lasts about 12 minutes. After that, the
light takes on the steady colour that was active prior to the
selected colour cycle. In any case, after one hour with no
activation of any key shown in figs. 1 an 2, the light goes off
by itself.
NOTE
To Next Page
Loading...
Need help?
General
