Attention New Spa Owner!
Congratulations on the purchase of your new Jacuzzi® spa! The following is a
list of automated functions performed by your spa. These functions are listed
below in an attempt to suppress any operational concerns you may have during
the rst 24 hours of ownership! Also listed below are important maintenance
recommendations you should observe on a regular basis to protect your new
investment.
Automated Spa Operations
Your new spa is equipped with an automated “clean-up” cycle that clears all
plumbing lines daily to promote maximum water sanitation. Each day at 12:00
PM (noon), each pump will activate and run for one minute. If either pump
has just nished a 20 minute time out, it will not automatically activate for the
clean-up cycle. Be aware, the factory programmed clean-up cycle cannot be
canceled or altered!
Maintain Healthy Spa Water
Always maintain your spa’s water chemistry within the following parameters:
With CLEARRAY™ Without CLEARRAY™
pH 7.4-7.6 7.4-7.6
Free chlorine no less than 1.0 ppm 3.0-4.0 ppm
Free bromine no less than 2.0 ppm 2.0-4.0 ppm
Total Alkalinity 100-120 ppm 100-120 ppm
Calcium Hardness 150-250 ppm 150-250 ppm
IMPORTANT: CLEARRAY™ Water Purication System is factory installed. If
the CLEARRAY™ system is altered or is not operating efciently then follow
the “without CLEARRAY™” water chemistry parameters as dened by the
Association of Pool and Spa Professionals. CLEARRAY™ requires an annual
lamp replacement to properly sanitize your water.
!
TO DECREASE RISK OF INFECTION OR DISEASE! Always maintain
your spa lter as outlined below to ensure healthy spa water. Refer to pages
78-80 (Sec. 15.0) for additional information.
Required Filter Maintenance
Your new spa is equipped with an advanced water ltration system that
provides unsurpassed water quality! To ensure maximum water quality at all
times, you should clean the skimming lter cartridge every three months, or as
necessary. See pages 78-80 (Sec. 15.0) for detailed lter cartridge cleaning
instructions.
Required Water Replacement
!
TO DECREASE RISK OF INFECTION OR DISEASE! You should
replace the spa’s water every 3 months. The frequency depends on a number
of variables including frequency of use, number of users and attention paid to
water quality maintenance. You will know it is time for a change when you cannot
control sudsing and/or you can no longer get the normal feel or sparkle to the
water, even though the key water balance measurements are all within the proper
parameters. See pages 87-89 (Sec. 16.0) for additional information.
To Next Page
Loading...
Need help?
General
