32
11.5 Programming the Circulation Pump Filtration Cycle
Press and hold the Jets pump 1 (
1
) and Cooler ( ) button at the
same time for 3 seconds to access the circulation pump programming.
Once you have entered the circulation pump ltration cycle, continually
press the Warmer ( ) or Cooler ( ) button to scroll up through the
cycles below. Then select a cycle and press the Jets pump 1
(
1
) button to activate that cycle. Upon pressing the jets pump 1 button
the system will save your selection, exit the program menu and return to
the main menu.
Note: After 10 seconds the programming screen will revert back to the
temperature if no buttons are pressed. You cannot have more than one
circulation pump cycle activated at a time.
0 hours of circulation per day
4 hours of circulation per day
8 hours of circulation per day (recommended factory
default setting)
12 hours of circulation per day
16 hours of circulation per day
20 hours of circulation per day
24 hours of circulation per day
Note: The recommended factory default setting for the JLX Collection is
8 hours. This setting should not be altered. Running the circulation pump
less than the factory recommended time might result in issues with water
quality maintenance.
To Next Page
Loading...
Need help?
General
