INSTALLATION
Be sure to comply with the local plumbing codes.
Be sure that all provisions for wastewater disposal meet local, state or national codes. Do
not discharge water where it will cause flooding or damage.
If the incoming water pressure is higher than the maximum peak pressure of 50psi, a
Pressure Regulating Valve (PRV) must be installed upstream of the filter inlet.
The PRV should be set to 90% of the maximum operating pressure of the tank.
If the incoming water flow is less than the filter’s minimum flow requirements, the filter’s
filtration efficiency will be affected, please consult Jacuzzi.
English
Total Head Loss (psi)
JMC16 Total Head Loss Curve
JMC16 | pg 08
To Next Page
Loading...
Need help?
General
