Jacuzzi Pinnacle User Manual

A. Clean strainer/skimmer.
B. Clean or replace filter.
C. See Chemistry section.
D. See Maintenance section.
E. Use clarifier or drain and refill
spa.
F. Check filter motor connection
on the electrical cabinet.
A. Repair leak.
B. Use rigid spa cover; lower
thermostat setting.
A. Fill to water level indicator mark
on skimmer/filter frame.
B. Clean strainers or skimmer
baskets.
C. Clean or replace filter.
D. Open jet.
E. *
F. *
G.*
H. Call an electrician or your power
company.
A. Turn ON power at service panel.
B. Press jets button.
C. Check motor plug connections
on electrical cabinet.
D. Reset circuit breaker.
E. Reset GFCI.
F. *
A. Clogged or blocked suction
strainer or skimmer basket.
B. Filter clogged (dirty).
C. Poor water chemistry.
D. Improper maintenance.
E. High content of solids in water.
F. Filter motor plug not connected
to the electrical cabinet.
A. Leak in suction line, discharge
line, or connections.
B. Excessive evaporation and/or
splashing.
A. Low water level.
B. Clogged or blocked suction
strainer or skimmer basket.
C. Dirty filter.
D. Adjustable jet partially closed.
E. Suction or discharge line partially
plugged.
F. Pump running at subnormal
speed.
G.Worn or damaged pump seal.
H. Subnormal voltage.
A. Power turned OFF.
B. Pump OFF.
C. Motor(s) not connected.
D. House circuit breaker tripped; no
power to system.
E. GFCI tripped.
F. Faulty pump or motor.
REMEDY
PROBABLE CAUSE
PROBLEM
1. Water not clean.
2. Abnormal water usage.
3. Low water flow from jets.
4. No water flow from jets.
*NOTE: See also DISPLAY MESSAGES.
*NOTE: The skills and tools necessary for the safe repair of this spa require the services of qualified service
personnel. Contact your Jacuzzi Whirlpool Bath dealer.
21
TROUBLESHOOTING GUIDE

Jacuzzi Pinnacle Specifications

General

Brand	Jacuzzi
Model	Pinnacle
Category	Hot Tub
Language	English

Summary

Important Safety Information

General Safety Precautions

Covers temperature limits, children, health conditions, alcohol use, and thermometer accuracy.

Electrical Safety Precautions

Details grounding, bonding, GFCI protection, and avoiding electrical devices near the spa.

Child Drowning Prevention

Emphasizes supervision of children and the importance of using spa covers.

Installation

Inspection and Shipping Claim

Positioning Your Spa

Electrical Requirements

Specifies power needs, wiring, circuit protection, and grounding.

Electrical Precautions

Warnings regarding water level, lighting placement, and device usage during operation.

Outdoor and Indoor Installation

Equipment Set-Up Procedure

Steps for initial setup, purging air, and sanitizing the system.

Operation

Operating Instructions and Initial Start-Up

Overview of spa operation, initial fill, and power-up sequence.

Control Panel Overview

Control Panel Operations

Temperature and Panel Lock Functions

Spa Features: Jets, Blower, Water Rainbow

Maintenance

Water Quality and Chemistry

Importance of maintaining water balance for hygiene and equipment longevity.

Filtration System Maintenance

Balancing pH and Total Alkalinity

Procedures for adjusting pH and total alkalinity for optimal water chemistry.

Water Level and Draining Procedures

Skimmer Basket and Filter Maintenance

Cycle Valve Strainer Cleaning

Pump/Motor Strainer and Skirt Access

Winterizing and Automatic Maintenance

Troubleshooting Guide

Water Quality and Flow Issues

Addresses problems like cloudy water, poor chemistry, and low water flow.

Jet and Pump Performance Problems

Troubleshooting for issues with jet pressure, pump operation, and water leakage.

Motor, Blower, and System Start Issues

Diagnosing problems with motors, air blowers, and failure to start.