25
Spotlight
T
hanks to the innovative LED digital lighting system, it is
possible to enhance the regenerating effect of the water
with an infinite combination of colours, mixed in just as many
sequences... and all with the simple press of a button.
N.B.: some models have a white light led spotlight.
X Press the key “Light” to activate the spotlight located
on the wall of the tub.
NOTE: some models have a white light led spotlight.
XWhen turned on, the programme will be activated that was
in use at the last shutdown.
In the instance where you wish to select the subsequent colour,
colour cycle to the one displayed, press the key twice within a
couple of seconds:
- with the rst command the spotlight goes o.
- with the second, the next colour cycle after the one that was
just turned o is activated.
To go back to initial display mode,scroll through the various
available options by repeatedly pressing the key.
XThe spotlight will stay on for two hours, but it can be turned
o before that by pressing the key again.
XThe colour combinations are regulated in terms of tones and
intensity by the built-in digital system.
Cromodream
This cycle allows you to experience the entire colour range - co-
lours appear in complimentary fashion, merging from one co-
lour to the next, providing complete satisfaction.
Sunlight
A colour trio (yellow/orange/white), with short interspersions of
sky blue and violet, reminiscent of the benecial eects of solar
light; yellow alternated with violet uplifts mood and improves
general physical balance.
Relax
Formed of the following colours: blue/orange/sky blue/white;
this sequence relieves stress and encourages relaxation; the
orange hue oers warmth in this sequence composed primarily
of “cold” colours.
Steady colours
You can also choose from the following colours, which appear in
stable fashion: white, light blue, orange, yellow, green.
Setting the time
f
or correct management of water filtering and use of the energy
savings mode, the current time must be set.
XPress the “Clock” key for about 5 seconds. The current
time will be displayed, the hour digit will ash, and the respecti-
ve symbol will appear on the display.
XUse the “Up” and/or “Down” keys to set the hour (Hold
the keys down for rapid change).
XThen press the “Clock”
key to set the minutes, which will
start ashing.
X Proceed as described above.
X Press the “Clock”
key again to save the set values and exit
the programming mode.
Displaying the time
X To display the time, press the “Clock” key .
NOTES
- If no key is pressed for 5 seconds, you will exit the procedure and
any changes made will not be saved.
- There is a back-up battery that keeps the time up-to-date even
when the system is powered o.