JWI-501
2-2 Character Prompt
dc x.xx：Mean the voltage of battery is x.xxv .
-----： Show this as the weight over 100%fs+9e, with the ding sounding, this means over
load, reduce the weight.
-batlo-：The voltage is lower. You can use it for a short while and recharge immediately.
c_end：Recharge is end.
err-0：Overload zero of loadcell. Re-adjust or change loadcell.
3 Operation guide
3-1 Install and adjust
Insert the pole into platform base and indicator, and tighten up screws. Adjust feet to let
the platform in level.
3-2 Turn on and turn off
Turn on：Press <ON/ZERO> key. It displays software version. After that, it will show
dc-x.xx(voltage of battery). Self-inspection starts. After countdown, the “zero” lamp will
light. Now the scale is in a working state.
Turn off：Press <OFF> key.
Auto turn off：When scale is in auto off state. It will be auto off after 10 minutes of no
operation.（ see 3-9-3 ）
Low voltage off: When the voltage is lower than 5.6v, it will auto turn off.
3-3 Zero
When without taring, the weight display is ≤4% max. capa.. Press < ON/ZERO>, then it
will shows “ 0 ”，and “zero” lamp is lighting.
3-4 Weighing
Put weight to pan, it shows the weight.
To Next Page
Loading...
Need help?
General
