M AX
M AX
M
A
X
OPERATION INSTRUCTIONS
6
Open the lid and ll the stainless steel tank with warm water (ideally 45 to
50°C). Do not exceed the “MAX” marking on the inside of the tank.
Place the item(s) to be cleaned into the water. If cleaning small items, then
place the basket in the tank rst. Ensure the item is immersed as fully as
possible, ensuring the water level does not exceed the “MAX” marking.
To avoid the possibility of scratches from friction during operation,
do not overlap items. Ensure items are spaced apart.
Close the lid and ensure your hands are dry. Plug the supplied mains cable
into the unit and then into the nearest mains outlet.
When the unit is plugged in, the display will show the 180 second (3
minute) setting. If a different time is required, press the SET button to
cycle the time through the ve settings 180s - 280s - 380s - 480s - 90s.
Move to the next step when the display shows your required time.
Press the ON button to start cleaning. The red operation indicator will
illuminate while the unit is in operation. The built in timer will count down
the time automatically.
Note: During operation the unit will “buzz”, this is normal.
When the timer counts down to 000 the unit will automatically stop.
If required, you can press the OFF button at any time to stop or pause
the cleaning process. Press the ON button again to resume cleaning and
continue the countdown. When cleaning has nished, you can press
the ON button again to repeat the process.
When cleaning has nished, unplug the unit from the mains and open the
lid to remove the item. Pour away the water and wipe the stainless steel
tank with a clean dry cloth.
3
Emptying the tank
• Remember to change the water between cycles as it becomes dirty.
• Always ensure the unit is unplugged when changing the water.
• Any waste concentrate should be disposed of via the local authority solvent disposal programme.
To Next Page
Loading...
Need help?
General
