Programming Set-Up Methods
There are two methods of setting up the hands-free elevator phone for
programming. Select the one applicable to your situation as described
below.
NOTE: The telephone line provided must be a touch-tone line.The phone
can be programmed at any location and then installed in the elevator cab.
The phone will retain its programming without the need for a battery.
Method A: Calling the elevator phone to program it.
1. From any touch tone phone, call the phone number to which the
elevator phone is connected.
2. After four rings (OR if the “CALL” button is pressed) the elevator phone
will turn on automatically and you will hear a diddle-diddle-diddle
sound.
NOTE: If there is more than one elevator phone on the same
phone line you will need to have someone press the “CALL” button on
each elevator phone, or disconnect the others, in order to program
each phone.
3. Go to the “Programming Instructions” section.
4. After programming the phone, you should test it by pressing the
“CALL” button. The test will ensure the phone is functioning correctly
and as programmed.
Method B: Using the keypad on the board to program it.
1. Disconnect the phone line from the P1 connector (TELCO) or the P1A
modular phone jack.
2. Connect a 9-volt battery to the battery clips on the board. (See
diagram of phone board)
3. Wait 30 seconds and then press the “PROGRAM” button above the
keypad.
4. Make sure the red light of the phone turns on. If it does not, go
back to step 3 and start again.
5. The elevator phone will turn on and you will hear a diddle-diddle-diddle
sound.
6. Go to the “Programming Instructions” section.
7. When you have completed the programming of the phone you can
unplug the 9-volt battery.
8. After programming the phone, you should test it by pressing the
“CALL” button. The test will assure the phone is functioning correctly
and as programmed.
5
Programming Instructions
1. Choose programming setup method A or B.
2. Enter # 94851 or # 9000000 to enter programming mode. Listen for
three beeps.
NOTE: Enter touch tone digits slowly and deliberately.
NOTE: Once you are in programming mode, you can perform any
programming step in any sequence as long as you get three beeps
after your programming entry.
To Next Page
Loading...
Need help?
General
