5
JB INDUSTRIES • DM4 Wireless Operating Manual • 630.851.9444 • sales@jbind.com
Change Pressure Units
1. Press the ENTER button to reach the main menu
2. Select and highlight Pressure Unit
3. Press the ENTER button
4. Scroll to the desired unit using UP s and DOWN t arrows
5. Press the ENTER button
6. On the left side of the screen “Data Saved” will show and the screens will be updated
Change Temperature Units
1. Press the ENTER button to reach the main menu
2. Select and highlight Temp Unit
3. Scroll to the desired unit using UP s and DOWN t arrows
4. Press the ENTER button
5. On the left side of the screen “Data Saved” will show and the screens will be updated
Zero Pressure to Atmosphere
To zero pressure to atmosphere press the ZERO button on the display
The unit will beep to acknowledge the transducers are zeroed to atmosphere
User Defined Calibration (Temperature)
1. Press the ENTER button to reach the main menu
2. Select and highlight User Cal
3. Press the ENTER button
4. Select and highlight Temperature Cal
5. Select ADJ Left for the left thermocouple or ADJ Right for the right thermocouple
6. Press the ENTER button
7. Use the UP s to change the temperature reading up one digit
8. Use the DOWN t to change the place of the cursor
9. Press ENTER button when complete
Reset User Defined Calibration (Temperature)
1. Press the ENTER button to reach the main menu.
2. Select and highlight User Cal
3. Press the ENTER button
4. Select and highlight Temperature Cal
5. Press the ENTER button
6. Select Reset Left for the left thermocouple or Reset Right for the right thermocouple
7. Press the ENTER button
8. This will reset to factory default settings; to reset both at the simultaneously select FACT Default
9. Press ENTER button when complete
To Next Page
Loading...
Need help?
General
