JBL 4365 User Manual

7
English
www.jbl.com
JBL
®
studio monitor model 4365
Low-frequency transducer: 380mm (15") cone driver with Vented Gap Cooling™, a 100mm (4")
voice coil and a three-layer sandwich cone (model 1501FE)
High-frequency transducer: 100mm (4") compression driver with magnesium-alloy diaphragm and
38mm (1-1/2") exit (model 476Mg)
Ultrahigh-frequency transducer: 25mm (1") compression driver with pure titanium diaphragm (model
045Ti-1)
Recommended amplifier power: 50W – 300W
Frequency response: 35Hz – 40kHz (–6dB, anechoic)
Nominal impedance: 8 ohms
Sensitivity: 93dB (2.83V/1m)
Crossover frequencies: 750Hz, 15kHz
Controls: Switch attenuators for HF and UHF drivers
Enclosure type: 25mm (1")-thick MDF stock, dual-ported
Connector type: Dual gold-plated five-way binding posts
Finish: Walnut, with polyurethane
Grille color: Monitor blue
Dimensions (H x W x D): 1048mm x 597mm x 429mm (41-1/4" x 23-1/2" x 16-7/8")
Weight: 86.4kg (190 lb)
sPeCIFICaTIONs
0219CSK - JBL Studio Monitor Model 4365 OM v1.indd 7 17/06/10 10:23:47

JBL 4365 Specifications

General

Nominal Impedance	8 Ohms
Frequency Response	30Hz - 40kHz
Recommended Amplifier Power	300 Watts
Woofer	15" (380 mm)
Tweeter	1" (25 mm)
Crossover Frequencies	800Hz

Summary

Introduction

Unpacking the Speaker

Changing the Speaker's Feet

Placement

Connections

Basic Single-Wire Connection

Connects the amplifier to each speaker using a single wire.

Using Bare Wire or Pin Connectors

How to connect bare wire or pin connectors to the speaker terminals.

Using Spade Connectors

How to connect spade connectors to the speaker terminals.

Using Banana Connectors

How to connect banana connectors to the speaker terminals.

Bi-Wire Connection

How to bi-wire the speakers using jumper wire removal.

Controls and Adjustments

High-Frequency Trim

Adjusts the high-frequency range balance of the speaker.

Ultrahigh-Frequency Trim

Adjusts the ultrahigh-frequency range balance of the speaker.

Caring for Your Speakers

Specifications