JBL ARC SUB10 User Manual

SPEAKER CONNECTIONS
Line Level
Note: Some receivers/amplifiers have
a single (mono) subwoofer output. In
this case, it is recommended that you
use a “Y”-connector (not included) to
connect to both right & left inputs and
maximize the subwoofers
performance.
Speaker Level
Note: When using the speaker-level
connections, the built-in high-pass
filter will also limit the low
frequencies being sent to the
satellite speakers. This means that
your satellites won't have to try to
reproduce the information the
subwoofer is playing.
10
Amplifier/Subwoofer ARC SUB10/DS-10
Min
50
Max
150
Volume
Crossover
Frequency
R
R
L
L
Power
SPKR
IN
SPKR
OUT
Low
Level
In
RIGHT
LOUDSPEAKER
LEFT
LOUDSPEAKER
MAIN SPEAKER OUTPUT
SUBWOOFER OUT
LEFT
LEFT
RIGHT
RIGHT
RECEIVER/AMPLIFIER
Min
50
Max
150
Volume
Crossover
Frequency
R
R
L
L
Power
SPKR
IN
SPKR
OUT
Low
Level
In
RIGHT
LOUDSPEAKER
LEFT
LOUDSPEAKER
MAIN SPEAKER OUTPUT
LEFT
RIGHT
RECEIVER/AMPLIFIER
Note: DS-10 controls are shown here

JBL ARC SUB10 Specifications

Power

amplifier power	100 watts

Driver

driver size	10 inches

Inputs and Outputs

inputs	Line- and high-level
outputs	High-level with high-pass filter at 180Hz

Frequency

crossover frequency	50Hz – 150Hz
frequency response	35Hz – 150Hz

Weight and Dimensions

dimensions	11-1/2 x 17-1/8 x 16-1/2 inches
dimensions metric	292 x 435 x 419mm
weight	27 lbs/12.3 kg