LED Indication Table
13
Authentics L8
If a new version is available, download it from the JBL website
and proceed with the following upgrade method:
1. Place the upgrade file downloaded from the website,
www.jbl.com onto the root directory of a USB drive.
2. Insert the USB drive into the top USB port on the
top panel (labeled iPad).
3. Press the Power and Source buttons
simultaneously for five seconds. The system will
automatically begin the upgrade process.
NOTE: The upgrade process normally takes up to
30 minutes to complete. Do not attempt to operate
or remove power from the system during the
upgrade process.
If the upgrade process has not completed after 1 hour,
restart the system by removing and reconnecting AC
power, then begin the upgrade process again.
Factory Setting Reset
To restore all settings to the factory defaults, press and hold the
power button for at least 10 seconds. The following settings
will be reset:
t Source
t Volume settings
t EQ settings
t AirPlay name
t Wi-Fi settings
LED State Indication
Power LED White, Constant Operational mode
Amber, Constant Sleep mode
Off OFF/Standby mode
Bluetooth LED White, Constant Bluetooth connected
White, Regular Flash Bluetooth disconnected and pairing mode
AirPlay LED White, On AirPlay source active, Wi-Fi info sharing
DLNA LED White, On DLNA source active, Wi-Fi Manual Connect mode
Aux-in LED White, Constant Aux-in source active
Optical LED White, Constant Optical source active
Volume LEDs White, Constant Volume Level
All LEDs Flash five times Factory settings restored
Wireless Charging White, On Charging device recognition
White, Breathing Charging
White, Quick Flash Error indicator
LED Indication Table
To Next Page
Loading...
Need help?
General
Weight and Dimensions
