EasyManuals Logo
Home>JBL>Home Theater System>CS1500

JBL CS1500 User Manual

JBL CS1500
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
4
SPEAKER PLACEMENT
SUBWOOFER
SURROUND SPEAKERS
FRONT
SPEAKERS
0–2 ft
0–0.6m
The front speakers should be
placed the same distance
from each other as they are
from the listening position.
The CSB5 speakers should be
placed at about the same
height from the floor as the
listeners’ ears will be, or they
may be angled toward the
listeners.
The center channel speaker
should be placed slightly
behind the front left and right
speakers, and no more than
2 feet (0.6m) above or below
the tweeters of the left and
right speakers. It is often
convenient to set the center
speaker on top of the
television set, as shown in the
drawing.
The JBL Cinema Sound
speaker system may be used
in 5.1-, 6.1- or 7.1-channel
applications. In 5.1-channel
applications, two of the
surround speakers should be
placed slightly behind the
listening position and, ideally,
should face each other and be
at a level higher than the
listeners’ ears. If that is not
possible, they may be placed
against a wall behind the
listening position, facing
forward. In 6.1-channel appli-
cations, two of the surround
speakers should be placed in
the side positions, and a
single surround back speaker
should be placed against the
wall behind the listening
position. In 7.1-channel
applications, place two of the
surround speakers in the side
positions, and place the two
surround back speakers
against the rear wall.
In Dolby
®
Digital and DTS
®
systems, it is best to aim all of
the speakers (except the
subwoofer) toward the
listening position at or slightly
above about ear-level height.
In systems where only analog
surround processing (such as
Dolby Pro Logic
®
II) is
available, it may be preferable
to aim the speakers straight
out from the wall to obtain a
more diffuse sound.
The low-frequency material
reproduced by the subwoofer
is mostly omnidirectional, and
this speaker may be placed in
a convenient location in the
room. However, bass
reproduction will be
maximized when the
subwoofer is placed in a
corner along the same wall as
the front speakers.
Experiment with subwoofer
placement by temporarily
placing the subwoofer in the
listening position and moving
around the room until the bass
reproduction is best. Place the
subwoofer in that location.
CENTER CHANNEL
SPEAKER
† Single surround back speaker
may be used with 6.1 receivers
and processors.
Alternate placement for surround speakers when only 5.1 channels are used; required placement for surround back
speakers in 7.1-channel systems.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JBL CS1500 and is the answer not in the manual?

JBL CS1500 Specifications

CST55

Power IconPower
maximum recommended amplifier power150 Watts
power handling50W Continuous/300W Peak
Acoustic Characteristics IconAcoustic Characteristics
frequency response55Hz – 30kHz (–6dB)
nominal impedance8 Ohms
sensitivity90dB @ 1 Watt/1 meter
Physical Specifications IconPhysical Specifications
dimensions1168 x 286 x 286mm (46" x 11-1/4" x 11-1/4")
weight7.7kg (17 lb)
tweeterOne 3/4" (19mm) titanium-laminate dome, video-shielded

CSB5

Power IconPower
maximum recommended amplifier power125 Watts
power handling40W continuous/300W peak
Acoustic Characteristics IconAcoustic Characteristics
frequency response60Hz – 30kHz (–6dB)
nominal impedance8 Ohms
sensitivity88dB @ 1 watt/1 meter
Physical Specifications IconPhysical Specifications
dimensions with base and grille363 x 155 x 116mm (14-5/16" x 6-1/8" x 4-9/16")
weight with base and grille2.3kg (5 lb)
dimensions without base338 x 155 x 130mm (13-5/16" x 6-1/8" x 5-1/8")

CSC55

Power IconPower
maximum recommended amplifier power150 Watts
power handling50W Continuous/300W Peak
Acoustic Characteristics IconAcoustic Characteristics
frequency response55Hz – 30kHz (–6dB)
nominal impedance8 Ohms
sensitivity90dB @ 1 watt/1 meter
Physical Specifications IconPhysical Specifications
dimensions159 x 667 x 108mm (6-1/4" x 26-1/4" x 4-1/4")
weight4.5kg (10 lb)
tweeterOne 19mm (3/4") titanium-laminate dome, video-shielded

CSS10

Power IconPower
amplifier power150 Watts RMS
Acoustic Characteristics IconAcoustic Characteristics
frequency response27Hz – Low-pass crossover setting at signal source
low-frequency driver250mm (10") cone and HeatScape™ motor structure, video-shielded
Physical Specifications IconPhysical Specifications
dimensions464 x 337 x 406mm (18-1/4" x 13-1/4" x 16")
weight19.5kg (43 lb)

Related product manuals