jcb 100 C-1 User Manual

15 - Engine
18 - Engine Belt
03 - Drive Belt
15 - 82 9813/2700-2 15 - 82
6. The tension of the belt should between the
specified values.
Weight/Force: 350–450N
7. If the tension values do not match the specified,
tighten the screws, then repeat the steps 1 to 6.
Alternate Belt Configuration
The belt must always be replaced every time it is
removed, even if it has not reached the scheduled
hours for replacement.
1. Make sure that the ribs of the belt are engaged
correctly into the grooves of the pulleys.
Figure 149.
B
A
A Drive belt
B Pulley pin
2. Make sure that the pulley pin is at the bottom of
the guide groove.
3. Tighten the screw, that attaches the pulley, to the
correct torque value.
Torque: 45N·m
4. Hold the tensioning screw with an Allen key.
5. Tighten the nut on the plate to secure the
tightening screw.
Torque: 45N·m
Figure 150.
D
E
C
F
C Screw
D Tensioning screw
E Nut
F Plate
6. Measure the tension of the belt at the point
shown.
Figure 151.
G
G Tension measuring point
7. The tension of the belt should between the
specified values.
Frequency: 149–196Hz
8. Run the engine for the specified duration.
Duration: 15–20min
9. Repeat the step 6 to 7.
10. The Poly-v drive belt is not adjustable. If the
tension value is not within the specified range
replace the drive belt.

jcb 100 C-1 Specifications

General

Brand	jcb
Model	100 C-1
Category	Excavators
Language	English