03 - Attachments, Couplings and Load Handling
10 - Excavator End Quickhitch
00 - General
03 - 7 9813/7900-2 03 - 7
00 - General
Introduction ...................................................... 03-7
Health and Safety ........................................... 03-8
Check (Condition) ............................................ 03-8
Remove and Install ......................................... 03-9
Introduction
Quickhitches are used on machines to allow the rapid
change of buckets and attachments on the machine.
Quickhitches do not normally have a specific function
themselves in that they do not carry out handling or
digging operations, but when installed on a machine
they become a part of the overall machine system.
They are usually mounted on the machine by means
of pins that would otherwise be the mountings for the
bucket or attachment.
To Next Page
Need help?
General
