About the Product
Product and Component Identification
11 9811/9500-4 11
Figure 7.
A Cylinder block location
Table 3. Example of the engine identification number
GP 50261 U 500405 M
Digit 1-2 3-5 6 7-12 13
Table 4. Explanation of the engine identification number
Digit Explanation
1-2 Engine type. GN = Normally Aspirated. GP = Tur-
bocharged.
3-5 Build Number
6 Country of manufacture
7-12 Engine Serial Number
13 Year of Manufacture
Operator Protective Structure
WARNING You could be killed or seriously injured if you operate a machine with a damaged or missing
ROPS/FOPS/FOGS. If the ROPS/FOPS/FOGS has been in an accident, do not use the machine until the
structure has been renewed. Modifications and repairs that are not approved by the manufacturer may be
dangerous and will invalidate the ROPS/FOPS/FOGS certification.
WARNING Machines with a ROPS, FOPS,FOGS or TOPS are equipped with a seat belt. The ROPS,
FOPS,FOGS or TOPS is designed to give you protection in an accident. If you do not wear the seat belt you
could be thrown off the machine and crushed. You must wear a seat belt when using the machine. Fasten
the seat belt before starting the engine.
ROPS Data Plate
Machines built to ROPS (Roll-Over Protective Structure) standards have an identification label installed inside
cab, below the operator seat. A bolt on FOPS (Falling Object Protective Structure) is available which also
carries a certified label installed to the guard.
FOPS Data Plate
WARNING Do not use the machine if the falling objects protection level provided by the structure is not
sufficient for the application. Falling objects can cause serious injury.
To Next Page
Loading...
Need help?
General
