7
21-DH1700
Instruction & User Manual
ELECTRICAL SAFETY
The electric motor has been designed
for operation on a 230-240V AC 50 Hz
power supply. 230-240V AC means your
tool will operate on alternating current
at a voltage range from 230-240V. As
little as 10% lower operating voltage
(or incorrect mains Hz frequency) can
cause loss of power and overheating.
All JCB tools are factory tested. If this
tool does not operate check the power
supply. Make sure your power supply
agrees with the voltage specified on the
product rating label.
m Replacement of the supply cord. If the
supply cord is damaged, it must be replaced
by the manufacturer or an authorised JCB
Service Centre in order to avoid a hazard.
We recommend the use of a
residual current device (R.C.D.)
with a residual current rating of
30mA or less.
This electric tool generates an
electromagnetic field during operation.
This field may under some circumstances
interfere with active or passive medical
implants. To reduce the risk of serious or
fatal injury, we recommend persons with
medical implants consult their physician
and the medical implant manufacture
prior to operating this power tool.
WARNING!
To Next Page
Loading...
Need help?
General
