About the Product
Product and Component Identification
10 9831/2700-3 10
Figure 6.
A Data plate - front axle (2WS machine) B Data plate - rear axle (2WS machine)
Gearbox
The gearbox has a serial number stamped on a data plate as shown.
Figure 7.
A Data plate
Operator Protective Structure
WARNING Do not use the machine if the falling objects protection level provided by the structure is not
sufficient for the application. Falling objects can cause serious injury.
Machines built to ROPS (Roll-Over Protective Structure)/FOPS (Falling Object Protective Structure) standards
have an identification label installed to the left hand side of the bulkhead. Refer to Figure 8.
The FOPS structure provides Level II impact protection against falling objects (as defined in ISO (International
Organization for Standardization) 3449:2005).
If the machine is used in any application where there is a risk of falling objects then a FOPS must be installed.
For further information contact your JCB dealer.
The FOPS is installed with a data plate. The data plate indicates what level protection the structure provides.
There are two levels of FOPS:
To Next Page
Loading...
Need help?
General
