Section 1 - General Information
Introduction
Identifying Your Machine
1-3 1-3
9813/4600-1
Identifying Your Machine
Machine Identification Plate
Your machine has an identification plate mounted as
shown. The serial numbers of the machine and its major
units are stamped on the plate.
Note: The machine model and build specification is
indicated by the PIN. Refer to Typical Product
Identification Number (PIN).
The serial number of each major unit is also stamped on
the unit itself. If a major unit is replaced by a new one, the
serial number on the identification plate will be wrong.
Either stamp the new number of the unit on the
identification plate, or simply stamp out the old number.
This will prevent the wrong unit number being quoted when
replacement parts are ordered.
The machine and engine serial numbers can help identify
exactly the type of equipment you have.
C091000
Fig 2. The plate is below the seat
Typical Product Identification Number
The PIN, weight, engine power and serial number of the
machine are stamped on the identification plate.
1 World Manufacturer Identification (3 Digits)
2 Machine Model (5 Digits)
3 Randomly Generated Check Letter (1 Digit)
4 Machine Serial Number (8 Digits)
Each machine has a unique serial number.
817-18435-2
Fig 3.
0
1
2
3
POWER
OUTLET
12V
1
0
F
R
JCB5 154 0L 9 1 627501
321
4
To Next Page
Loading...
Need help?
General
