About the Product
Product and Component Identification
13 9831/4000-2 13
Axle
The axles have a serial number stamped on a data plate as shown.
Figure 6. Front axle
A Data plate - front axle
Figure 7. Rear axle
B Data plate - rear axle
Operator Protective Structure
WARNING You could be killed or seriously injured if you operate a machine with a damaged or missing
ROPS/FOPS. If the ROPS/FOPS has been in an accident, do not use the machine until the structure has
been renewed. Modifications and repairs that are not approved by the manufacturer may be dangerous and
will invalidate the ROPS/FOPS certification.
WARNING Machines with a ROPS/FOPS are equipped with a seat belt. The ROPS/FOPS is designed to
give you protection in an accident. If you do not wear the seat belt you could be thrown off the machine and
crushed. You must wear a seat belt when using the machine. Fasten the seat belt before starting the engine.
FOPS Data Plate
WARNING Do not use the machine if the falling objects protection level provided by the structure is not
sufficient for the application. Falling objects can cause serious injury.
If the machine is used in any application where there is a risk of falling objects then a FOPS (Falling Object
Protective Structure) must be installed. For further information, contact your JCB dealer.
To Next Page
Loading...
Need help?
General
