65R-1, 67C-1, 85Z-1, 86C-1, 90Z-1, 100C-1 25
Troubleshooting/FAQs
Issue / FAQ Resolution/Answer
How do I release pressure from my
Auxiliary system?
Turn key to position 1, enter immobiliser code (if required). Enable
Hydraulic controls, select Aux function using top button on left control
lever which will display Aux status. Select required function using
Aux mode select on right hand console and using elec-prop roller on
control levers, fully rotate both in both directions to release stored
system pressure.
How do I adjust my Aux flow
(high Flow) ?
When the ignition is on and the Aux controls are activated the
maximum flow can be changed by pressing the rocker switch up to
position 1 shown in the handbook.
How do I change power mode
function?
Power mode can be change using the momentary rocker switch on
the right hand console.
This allows you to switch between ECO and Heavy Mode.
What are the max flow of the
Auxiliary circuits?
The maximum flow for the hydraulic circuits are as follows:
• High flow – 100 l/min (8-10t)
• High flow – 100 l/min (6t)
• Low flow – 25 l/min (6-10t)
Is it possible to turn off the lift
overload buzzer?
Yes this can be done using the momentary rocker switch on the right
hand console when the ignition switch is in the on position.
To Next Page
Loading...
Need help?
General
