01 - Machine
03 - Safety
27 - Maintenance Positions
01 - 13 9813/8950-2 01 - 13
movement immediately when the weight of
the dumper is supported by the safety strut.
Figure 2.
A Maintenance strut - installed position
Remove
1. Fully raise the dumper to take the weight off the
safety strut.
2. Stop the engine and remove the ignition key.
3. Remove the strut.
3.1. Loosen the strap.
3.2. Remove the strut from the ram piston rod.
4. Stow the strut.
4.1. Secure the strut in the stowage position with
fastener. Refer to Figure 3.
Figure 3.
A Maintenance strut - stowage position
(For: 6T-1 Swivel Tip)
Dumper Body Lowered
1. Park the machine on level solid ground.
2. Lower the dumper.
3. Apply the park brake.
4. Stop the engine and remove the ignition key.
5. Disconnect the battery to prevent accidental
operation of the engine.
6. If necessary, put blocks against the two sides of
the wheels before you get below the machine.
Dumper Body Raised
DANGER A maintenance strut or other method
of supporting the skip in the raised position must
be installed and locked in position before working
under a raised skip. Do not reach or work under
a raised skip unless a prop is installed.
If you raise the dumper to get access for
maintenance, you must install the maintenance strut
on the dumper.
The maintenance strut is only for use with a empty
dumper.
Install
1. Discharge any material from the dumper.
2. Fully raise the dumper.
3. Remove the grip clip and pin. Refer to Figure 4.
4. Raise the dumper support from its storage
bracket.
5. Align the hole in the dumper support with the
holes in the dumper rail.
6. Install the pin and secure with the grip clip.Refer
to Figure 4.
To Next Page
Loading...
Need help?
General
