About the Product
Product and Component Identification
11 9821/6200-7 11
Figure 5.
A Engine data label
Operator Protective Structure
WARNING Machines with a ROPS, FOPS,FOGS or TOPS are equipped with a seat belt. The ROPS,
FOPS,FOGS or TOPS is designed to give you protection in an accident. If you do not wear the seat belt you
could be thrown off the machine and crushed. You must wear a seat belt when using the machine. Fasten
the seat belt before starting the engine.
WARNING Do not use the machine if the falling objects protection level provided by the structure is not
sufficient for the application. Falling objects can cause serious injury.
WARNING You could be killed or seriously injured if you operate a machine with a damaged or missing
ROPS/FOPS/FOGS. If the ROPS/FOPS/FOGS has been in an accident, do not use the machine until the
structure has been renewed. Modifications and repairs that are not approved by the manufacturer may be
dangerous and will invalidate the ROPS/FOPS/FOGS certification.
ROPS and TOPS Data Plate
Machines built to the ROPS (Roll-Over Protective Structure) and TOPS (Tip-Over Protective Structure)
standards have an identification label attached to the cab/canopy.
Figure 6.
A ROPS and TOPS identification label
General specification is TOPS compliant. In some configurations, 85Z-1 and 86C-1 can be considered ROPS
compliant if the operating mass of the machine is less than 9,000 kg.
FOPS Data Plate
If the machine is used in any application where there is a risk of falling objects then a FOPS (Falling Object
Protective Structure) must be installed. For further information, contact your JCB dealer.
The FOPS has a data plate attached. The data plate indicates what level of protection the structure provides.
To Next Page
Loading...
Need help?
General
