About the Product
Interior Switches
19 9821/7950-3 19
Interior Switches
Ignition Switch
The ignition key operates the three-position ignition switch. The ignition key can only be inserted or removed
in position 0.
If the engine fails to start, the ignition key must be returned to position 0 before the starter motor is re-engaged.
Do not operate the starter motor for more than 20s without the engine firing. If the engine fires but does not
fully start, let the starter motor cool for at least 2min between starts.
Figure 13.
A Ignition switch
B Ignition key
Table 7. Switch Positions
Position Function
0 Off/Stop the Engine: Turn the ignition key to this position to stop the engine.
Make sure the controls are in neutral and the mast is lowered before you stop
the engine.
I On: Turn the ignition key to this position to connect the battery to all of the elec-
trical circuits. The ignition key will return to this position when it is released from
position II.
II Start: Turn the ignition key to this position to operate the starter motor and turn
the engine. The ignition switch has an inhibitor to stop the ignition switch being
turned on when the engine is running. If a grid heater is fitted there may be a de-
lay between switch operation and engine cranking dependant on the ambient
temperature.
Multi-Purpose Switch
Direction Indicators
Push the stalk forwards to indicate a left turn. Pull the stalk backwards to indicate a right turn. Place in central
position to cancel.
Windscreen Wiper
Rotate the switch barrel to activate and cancel the windscreen wipers. The wiper speed can vary dependant
on machine specification.
Single Speed (Standard)
0 = Off
I = On
Two Speed (Optional)
J = Intermittent Wipe
To Next Page
Loading...
Need help?
General
