PROBLEM SOLVING
1. WHY DOES THE DRILL NOT TURN ON WHEN YOU PRESS THE
SWITCH?
The forward/reverse rotation control, which is on top of the trigger, is positioned in
the lock function. Unlock the forward/reverse rotation control by putting it into the
required rotation position. Push the trigger and the drill will start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW IS COMPLETELY
TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring, you can find the torque-
adjusting ring between the chuck and the drill body. Position 1 is the lowest torque
(screw driving force) and position 15 is the highest torque (screw driving force).
Position
is for drill operation. Regulate the torque adjusting ring to a higher
position to reach the best result.
3. REASONS FOR DIFFERENT BATTERY PACK WORKING TIMES
Charging time problems, as above, and having not used a battery pack for a
prolonged time will reduce the battery pack working time. This can be corrected
after several charge and discharge operations by charging & working with your
drill. Heavy working conditions such as large screws into hard wood will use up
the battery pack energy faster than lighter working conditions. Do not re-charge
your battery pack below 0
o
C and above 45
o
C as this will affect performance.
MAINTENANCE
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use water or
chemical cleaners to clean your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor ventilation slots clean. Keep
all working controls free of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage your power tool.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authorities or retailer
for recycling advice.
To Next Page
Loading...
Need help?
General