Introduction
Safety Check List
14 14
9821/1350-8
!MWARNING
Fluid Under Pressure
Fine jets of fluid at high pressure can penetrate the
skin. Keep face and hands well clear of fluid under
pressure and wear protective glasses and gloves.
Hold a piece of cardboard close to suspected leaks
and then inspect the cardboard for signs of fluid. If
fluid penetrates your skin, get medical help
immediately.
INT-3-1-10_3
!MWARNING
Hydraulic Pressure
Hydraulic fluid at system pressure can injure you.
Before connecting or removing any hydraulic hose,
residual hydraulic pressure trapped in the service
hose line must be vented. Make sure the hose service
line has been vented before connecting or removing
hoses. Make sure the engine cannot be started while
the hoses are open.
INT-3-1-11_2
!MWARNING
Fuel
Fuel is flammable; keep naked flames away from the
fuel system. Stop the engine immediately if a fuel leak
is suspected. Do not smoke while refuelling or
working on the fuel system. Do not refuel with the
engine running. Completely wipe off any spilt fuel
which could cause a fire. There could be a fire and
injury if you do not follow these precautions.
INT-3-2-2_3
!MWARNING
Oil
Oil is toxic. If you swallow any oil, do not induce
vomiting, seek medical advice. Used engine oil
contains harmful contaminants which can cause skin
cancer. Do not handle used engine oil more than
necessary. Always use barrier cream or wear gloves to
prevent skin contact. Wash skin contaminated with oil
thoroughly in warm soapy water. Do not use petrol,
diesel fuel or paraffin to clean your skin.
INT-3-2-3
!MCAUTION
It is illegal to pollute drains, sewers or the ground.
Clean up all spilt fluids and/or lubricants.
Used fluids and/or lubricants, filters and contaminated
materials must be disposed of in accordance with
local regulations. Use authorised waste disposal sites.
INT-3-2-14
!MWARNING
Soft Ground
A machine can sink into soft ground. Never work
under a machine on soft ground.
INT-3-2-4
!MWARNING
Always wear safety glasses when dismantling
assemblies containing components under pressure
from springs. This will protect against eye injury from
components accidentally flying out.
GEN-6-2
!MCAUTION
Rams
The efficiency of the rams will be affected if they are
not kept free of solidified dirt. Clean dirt from around
the rams regularly. When leaving or parking the
machine, close all rams if possible to reduce the risk
of weather corrosion.
INT-3-2-10
!MCAUTION
Cleaning
Cleaning metal parts with incorrect solvents can cause
corrosion. Use only recommended cleaning agents
and solvents.
INT-3-2-11
!MWARNING
When using cleaning agents, solvents or other
chemicals, you must adhere to the manufacturer's
instructions and safety precautions.
GEN-1-9
To Next Page
Loading...
Need help?
General
